Fro 2025
Hello, CCNA exam!
leads4pass 200-301 Dumps solves puzzles for all candidates and contains 1604 latest CCNA exam questions and answers to help you pass the 2025 exam with 100% success.
All candidates can choose to use leads4pass 200-301 dumps: https://www.leads4pass.com/200-301.html with 200-301 dumps PDF, 200-301 dumps VCE, or PDF+VCE for efficient learning Latest CCNA exam questions.
For 2025 leads4pass 200-301 dumps exam questions and answers:
| Number of exam questions | Exam name | Exam code | Updated |
| 15 | Implementing and Administering Cisco Solutions (CCNA) | 200-301 | 2024.12.27 |
New Question 1:
Refer the exhibit.
What is the cause of poor performance on router R19?
A. excessive collisions
B. speed and duplex mismatch
C. port oversubscription
D. excessive CRC errors
Correct Answer: A
New Question 2:
Refer to the exhibit.
An administrator is tasked with configuring a voice VLAN. What is the expected outcome when a Cisco phone is connected to the GigabitEthernet 3/1/4 port on a switch?
A. The phone and a workstation that is connected to the phone do not have VLAN connectivity.
B. The phone sends and receives data in VLAN 50, but a workstation connected to the phone sends and receives data in VLAN 1.
C. The phone sends and receives data in VLAN 50, but a workstation connected to the phone has no VLAN connected.
D. The phone and a workstation that is connected to the phone send and receive data in VLAN 50.
Correct Answer: B
New Question 3:
An administrator must secure the WLC from receiving spoofed association requests. Which steps must be taken to configure the WLC to restrict the requests and force the user to wait 10 ms to retry an association request?
A. Enable Security Association Teardown Protection and set the SA Query timeout to 10
B. Enable MAC filtering and set the SA Query timeout to 10
C. Enable 802.1x Layer 2 security and set me Comeback timer to 10
D. Enable the Protected Management Frame service and set the Comeback timer to 10
Correct Answer: D
“You then need to specify the comeback timer and SA query timeout. The comeback timer specifies the time that an associated client must wait before the association can be tried again…” https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/212576-configure-802-11w-management-frame-prote.html
New Question 4:
Which command enables IPv6 forwarding on a Cisco router?
A. ipv6 local
B. ipv6 host
C. ipv6 unicast-routing
D. ipv6 neighbor
Correct Answer: C
To enable IPv6 routing on the Cisco router use the following command:
ipv6 unicast-routing
If this command is not recognized, your version of IOS does not support IPv6.
New Question 5:
DRAG DROP
Drag and drop the characteristic from the left onto the cable type on the right.
Select and Place:
Correct Answer:
New Question 6:
Which plane is centralized by an SON controller?
A. management-plane
B. control-plane
C. data-plane
D. services-plane
Correct Answer: B
Question 7:
Refer to the exhibit.
The DHCP server is configured with a DHCP pool for each of the subnets represented. Which command must be configured on switch SW1 to allow DHCP clients on VLAN 10 to receive dynamic IP addresses from the DHCP server?
A. SW1(config-if)#ip helper-address 192.168.10.1
B. SW1(config-if)#ip helper-address 192.168.20.1
C. SW1(config-if)#ip helper-address 192.168.20.2
D. SW1(config-if)#ip helper-address 192.168.10.2
Correct Answer: C
New Question 8:
What does a switch do when it receives a frame whose destination MAC address is missing from the MAC address table?
A. It floods the frame unchanged across all remaining ports in the incoming VLAN.
B. It appends the table with a static entry for the MAC and shuts down the port.
C. It updates the CAM table with the destination MAC address of the frame.
D. It changes the checksum of the frame to a value that indicates an invalid frame.
Correct Answer: A
New Question 9:
DRAG DROP
Refer to the exhibit.
Drag and drop the learned prefixes from the left onto the preferred route methods from which they were learned on the right. Not all prefixes are used.
Select and Place:
Correct Answer:
New Question 10:
Refer to the exhibit.
PC A is communicating with another device at IP address 10.225.34.225. Through which router does router Y route the traffic?
A. Rrouter A
B. Rrouter B
C. Rrouter C
D. Rrouter D
Correct Answer: C
10.128.0.0/9
Obviously is included, but not the longest match.
10.224.0.0/15
Starts: 10.224.0.0
Ends: 10.225.255.255
10.255.34.255 IS included
10.224.0.0/11 Starts: 10.224.0.0 Ends: 10.255.255.255
10.255.34.255 IS NOT included
New Question 11:
DRAG DROP
Drag and drop the AAA features from the left onto the corresponding AAA security services on the right. Not all options are used.
Select and Place:
Correct Answer:
New Question 12:
Refer to the exhibit. Router R1 resides in OSPF Area 0. After updating the R1 configuration to influence the paths that it will use to direct traffic, an engineer verified that each of the four Gigabit interfaces has the same route to 10.10.0.0/16. Which interface will R1 choose to send traffic to reach the route?
A. GigabitEthernet0/0
B. GigabltEthornet0/1
C. GigabitEthernet0/2
D. GigabitEthernet0/3
Correct Answer: B
ref BW 100000 MB
ref BW BW G0/0 100000MB divided by 10000MB (or 10000000KB) = 10 cost
G0/1 100000MB divided by 100000MB (or 100000000KB) = 1 cost
New Question 13:
What must be considered before deploying virtual machines?
A. resource limitations, such as the number of CPU cores and the amount of memory
B. support for physical peripherals, such as monitors, keyboards, and mice
C. whether to leverage VSM to map multiple virtual processors to two or more virtual machines
D. location of the virtual machines within the data center environment
Correct Answer: A
New Question 14:
An office has 8 floors with approximately 30-40 users per floor. What command must be configured on the router Switched Virtual Interface to use address space efficiently?
A. ip address 192.168.0.0 255.255.0.0
B. ip address 192.168.0.0 255.255.254.0
C. ip address 192.168.0.0 255.255.255.128
D. ip address 192.168.0.0 255.255.255.224
Correct Answer: B
need ip count: 30-40 * 8 = 320 ip
255.255.254.0 – 510 IP
New Question 15:
Refer to the exhibit.
When an administrator executes the show ip route command on router D to view its routing table, which value is displayed for the administrative distance for the route to network 192.168 1.0?
A. 110
B. 120
C. 170
D. 90
Correct Answer: A
If you test in Packet Tracer, you will see that every route redistributed from another protocol (interface X) on the router to (interface Y) OSPF, appears ON THE NEXT router as “O E2”, but the administrative distance remains the same “AD 110”.
Unlike EIGRP – when a router receives a redistributed route from another protocol (in this case RIPv2), it will appear as an EIGRP route with the initials “D EX”, but its administrative distance will no longer be 90, in this case it will appear as “AD 170”.
In the question we have both, AD 110 (O E2) or AD 170 (D EX) for the same destination network 192.168 1.0. AD 110 will be the winner and will appear in the routing table of router D… AD 170 will be a backup and will only be displayed if the first one fails.
…
Hello, CCNA exam candidates:
Download CCNA 200-301 dumps: https://www.leads4pass.com/200-301.html Study the latest 200-301 exam questions and answers to prepare you for passing the CCNA exam in 2025.